Front License Plate Mount – 2004-2009 Honda S2000 AP2

Replace a broken or missing front license plate mount on your 2004-2009 Honda S2000 AP2 with this 3D-printed part, produced to order by PartsRemade.

About this part

Installs on OEM front bumper of AP2 S2000 (2004 and newer). I'm not sure of the fitment for AP1. Model has 20 degrees of backward tilt for cool factor :) It probably also helps with wind deflection.

Choose either the half plate or the full plate. Half plate mount probably supports license plate enough, but it still might bend over time due to debris hitting it or wind damage. If the model scaling is weird, the width should be 220mm on both. Recommend using supports on the larger overhangs.

Additional parts needed to install:
- 3M VHB tape applied to top edge
- 3x M6 25mm screws
- 3x M6 nylon locking nuts (or regular nut + thread lock)
- 3x M6 washers
- (optionally) 2x M6 extra screws, nuts, and washers if using the full backing plate

Install steps:
1. Attach 3M VHB tape to the top where it will contact the bumper (leave protective film on for now)
2. Use a screw to attach to the existing hole in the plastic grill. I used washers whenever a screw was contacting the PLA print (so it didn't crush as easily)
3. Remove red film on VHB tape and stick it to bumper
4. Install license plate

Compatible vehicles

• 2004-2009 Honda S2000 AP2

Always compare with your original part before ordering. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

How to order

This part is in our catalogue and is printed on request. Send us a request with your vehicle details and we will reply with a price and delivery time.

More Honda parts

Browse all Honda replacement parts or search the full 3D-printed car parts catalogue.

Design credit: original design on Thingiverse, licensed CC BY-SA-4.0.