Rear Seatbelt Guide – 2020-2026 Tesla Model Y

Replace a broken or missing rear seatbelt guide on your 2020-2026 Tesla Model Y with this 3D printable part from PartsRemade.

About this part

You're looking at a single part you can install under the headrests of the second row seats on a Tesla Model Y to make it much easier for your rear passengers to find and grab the seat belt. Without this, your rear passengers must reach back behind their seat or they may even need assistance to find it at all.

To install this, follow the steps outlined in the attached image to remove each headrest. Slide the headrest post through the hole while aligning the notch with the other post so the part cannot rotate freely. Leave the part near the end of the posts, then attach your headrest and lower it into place forcing the part to slide evenly up the posts.

NOTE: When installed, your rear seat headrests will not lower all the way down to their original position. There will be a small gap necessary for the seat belt support to extend out the side under the headrest.

Compatible vehicles

• 2020-2026 Tesla Model Y

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

More Tesla parts

Browse all Tesla replacement parts or search the full 3D printable car parts library.

Design credit: original design on Thingiverse, licensed CC BY-4.0.