J1772 Adapter Trunk Holder – 2023 Tesla Model Y

3D printable replacement j1772 adapter trunk holder made for the 2023 Tesla Model Y: download the STL file and print a replacement for a cracked, lost or hard-to-find original part.

About this part

This design uses the charger emergency release compartment of the Model Y as a place to mount the holder. This design allows quick install and removal process without any use of tools or hair dryer.

Installation Instructions:
Insert the top triangle section into the Triangle cut out (Charger Emergency Release) on the left side.
Turn/twist the holder to have the flat surface face out and the holder should snug in place and won't fall out.

Removal Instructions:
Turn/twist the holder to align the cut out triangle hole with the holder.
Slowly tilt and slide the holder out.

Recommendation :
1. Use support for the small triangle.
2. Print in PETG if possible especially in regions with high temperature.
3. Apply small tape to the top of the lager triangle to prevent plastic to plastic contact and possible scratches. I used FlexTape but Electrical tape should work (refer to third image)
4. Attached a second file with lager gap between the two triangles.

Compatible vehicles

• 2023 Tesla Model Y

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

More Tesla parts

Browse all Tesla replacement parts or search the full 3D printable car parts library.

Design credit: original design on Thingiverse, licensed CC BY-SA-4.0.