3sgte Cam Seal Installation Tool – 1984-2007 Toyota Mr2

Need a replacement 3sgte cam seal installation tool for your 1984-2007 Toyota Mr2? This 3D model lets you print a replacement for a broken, worn or missing original piece.

About this part

This tool allows you to press in a cam seal with the motor in the car. Specifically, this was made to do the intake cam seal, since the strut tower is in the way of using a hammer. This piece is meant to be a tight fit so that it goes in straight and is held centered. You can use the same bolt that holds the pulley on, just tap it in, or give it a twist. If you use 100% infill you'll probably blow some of the material out the back if you hammer it in. Just tap it, and then twist it on. Thread it into the cam, and then use a wrench to tighten it down. Once it gets snug, that's it. I designed it so that when the tool bottoms out, the seal is fully seated. Remove the bolt, and then to get it off all you need to do is give it a light tap with a flathead. When it comes to removing or reinstalling the pulley try using a long bolt with some nuts and washers. This will work for gen2/3. Not sure if it'll work for gen 4/5.

Compatible vehicles

• 1984-2007 Toyota Mr2

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

More Toyota parts

Browse all Toyota replacement parts or search the full 3D printable car parts library.

Design credit: original design on Thingiverse, licensed CC BY-4.0.