Ball Mount 67 Designs for Yaesu FTM-400 – Universal Fit

3D printable ball mount 67 designs for yaesu ftm-400 made for the car: download the STL file and print a replacement for a cracked, lost or hard-to-find original part.

About this part

This is a 20mm ball adapter I made to work with my 67 Designs dash mount in my Jeep to install the radio controller head for my Yaesu FTM-400XDR VHF/UHF transceiver. It's designed for using an M5x20 machine screw with a 10mm wide lock washer. It probably would also work with Ram mounts which have similar clamps, but that's not tested. I made the stem a little thicker to add strength for holding my radio controller in bumpy situations. I didn't use supports during printing which may account for the bit of roughness on the lower half of the ball, but I figure the supports would leave just as many artifacts to clean up, so this was easier. I get the same with all ball mounts I've tried printing. I make no claims as to the durability or suitability of this design and makers assume all risk of its printing and use. FTM-400 users, the M5x20 screws and lock washers are included with the radio in the accessories bag. I use one lock washer inside and one lock washer outside to secure the control head. Update: I just added a 1-inch ball version. Uses the same M5x20 screw with 10mm wide lock washer. This seems to be a more common size for Ram mounts.

Compatible vehicles

• Universal fit – check the measurements against your vehicle

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

Design credit: original design by Max Becker on Thingiverse, licensed CC BY 4.0.