Gas Pedal Mount for E46 – BMW E46
Gas Pedal Mount for E46 – BMW E46
3D printable gas pedal mount for e46 made for the BMW E46: download the STL file and print a replacement for a cracked, lost or hard-to-find original part.
About this part
If your BMW gas (drive by cable) pedal mount breaks off, and you don't want to rip all your carpeting out to weld in a new mount. this may be the solution for you. This should fit for any E46/36/39 drive by cable pedals (only been tested on an E46) This piece is meant to be put in the area where the previous mount was. recessed into the carpeting and touching the floor pan. The recess in the bottom of the part is meant for a bolt that has a 8.2mm diameter and 3mm deep head, with a 4.8mm threaded section. Although these dimensions can be altered to fit whatever hardware you may have. Rotate the piece so the two holes for the screw are facing the bottom. You are meant to drill the two small holes into the floor pan. and bolt it into place from underneath the car. (use a little bit of some rubber sealant to make sure it is weather proof) The OEM pedal has two tabs on either side of the lock tab that has to be shaved flat on the inside of the mounting part.
Compatible vehicles
- BMW E46
Always compare with your original part before printing. Fitment can vary by trim level and production date.
Specifications
| Part | Gas Pedal Mount for E46 |
|---|---|
| Category | Mechanical/Functional |
| Make | BMW |
| Model | E46 |
| Format | Digital download – STL file for FDM 3D printing |
| Part number | CAT-P04246 |
What you get
A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.
More BMW parts
Browse all BMW replacement parts or search the full 3D printable car parts library.
Design credit: original design by Ahamed Khan on Thingiverse.