Trunk Lid Rubber Bumper Stop – 1989-1994 Nissan 200sx S13

3D printable trunk lid rubber bumper stop for the 1989-1994 Nissan 200sx S13: download the STL file and print an affordable replacement for a discontinued or expensive original part.

About this part

Trunk door rubbers/seals for Nissan 200SX S13.

When fitting the rubbers, the trunk door should sit flush with the chassis once closed.

Note: If necessary, adjust the height of the lock (2 nuts) until it closes without effort and opens with just one turn of the key without having to hold it.

If the lock cannot be adjusted to open at a touch — and in some cases the trunk light stays on — it is very common for this to be caused by a nylon component inside the lock mechanism which disintegrates with age. The solution is: after removing the remains, clean and lubricate the area with lithium grease, then place a small piece of rubber inside the lock mechanism, which can be easily manipulated with pliers or a fine screwdriver to position it. In my case I cut a piece approximately 20x20mm from an old coolant hose. Afterwards, re-adjust the lock with the two nuts.

Compatible vehicles

• 1989-1994 Nissan 200sx S13

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

More Nissan parts

Browse all Nissan replacement parts or search the full 3D printable car parts library.

Design credit: original design on Thingiverse, licensed CC BY-4.0.