Trunk Strut Bushing – 1996-2002 Toyota 4runner 3rd Gen

3D printable replacement trunk strut bushing made for the 1996-2002 Toyota 4runner 3rd Gen: download the STL file and print a replacement for a cracked, lost or hard-to-find original part.

About this part

These are just a simple design for spacers for your trunk struts to replace the worn out bushings. This is made specifically for a 3rd generation 4runner. Specifically, the Strong Arm 4286 struts, as long as the spacing is the same, these should work.
I recommend using PETG just so it doesn't deform in hot environments. It printed in about 18minutes on a Bambu P1S and overall cost is about 15 cents in filament.
For each side you'll need:
1x TopBushingInner
1x TopBushingOuter (the outer one is thicker and goes on the side facing into the trunk)
Either 2x MainBTMBushings1-2Hole or 2x PrototypeBTMBushing7-16Hole.
The main difference is that the prototype has tighter tolerances by 1/16inch however, I haven't been able to check if it would work. The main version is tested and work.
In total you'll need
For top sides of the struts:
2x TopBushingInner
2x TopBushingOuter
For bottom side of the struts:
4x MainBTMBushings1-2Hole or 4x PrototypeBTMBushing7-16Hole

Compatible vehicles

• 1996-2002 Toyota 4runner 3rd Gen

Always compare with your original part before printing. Fitment can vary by trim level and production date.

Specifications

Print settings

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed

What you get

A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.

More Toyota parts

Browse all Toyota replacement parts or search the full 3D printable car parts library.

Design credit: original design on Thingiverse, licensed CC BY-SA-4.0.