KIA eNiro MY20/21 Frunk
KIA eNiro MY20/21 Frunk
Need a replacement kia eniro my20/21 frunk for your 2021 Kia Niro, 2020 Kia Niro? This 3D model lets you print a replacement for a broken, worn or missing original piece.
About this part
List of parts Parts printed - 1x support large, height: 65mm - 1x support large, height: 45mm - 2x support small (~3mm gap between parts) Other Parts - 4x original rubber damper (2x OD 30mm and 2x OD 22mm) taken out of the original plastic motor cover - Eurobox with lid - 8x carriage bolt M8x30 - 8x washer M8 - 8x nut M8 Design changes In this remix of the original supports we changed the following to the design using the free Onshape CAD tool - Added a radius to all sharp corners/edges to prevent stress concentrations - Added a big radius to the inside corners where the flange connects to the cylinder on the two big supports - Adjusted the inner diameter of the cylinders to fit the original rubber dampers from the KIA motor cover/cap instead of printing rubber dampers and fitting those (see pictures) - Reduced the height of all 4 cyclinders by 5mm to compensate for the original dampers which protrude 5mm when the largers damper diameter is flush with the top of the cylinder (see pictures) - Increased the inner diameter of the through holes to 8.5mm for a easier fit of the bolts - The through holes have a chamfer at the bottom, so that the square start of the bolts fit well. - Added small radii at all outer corners for better printabillity Printing For Slicing Ultimaker Cura was used. The whole set was printed in one run. - Total build size ~126x190x65mm (~3mm spacing between parts) - PLA matt black from reel. Approx. 250g needed in total (71.2m of 1.75mm wire). - No support needed, no overhang. - Layer height 0.2mm - 35% infill cubic (higher infill has little effect) - Wall lines: 3 (1.2mm) - Infill overlap: 45% (overlap between infill and the walls, for better adhesion of the infill) - Speed: 55 mm/s (infill 110, walls 27.5, first layer 27.5mm/s) - Brim, only on outside: 5 lines, for better adhesion to the printbed The set was printed on a Anet ET5 Pro in just under 20h. Only the brim needed to be removed before assembly. Assembly - 8 carriage bolts M8x30 to minimize the protrusions inside the box - Normal nuts instead of self-locking (and washers) to prevent excessive stress of the carriage bolts on the box floor in the box holes. - Same Bauhaus eurobox and lid as the original.
Compatible vehicles
- 2021 Kia Niro, 2020 Kia Niro
Always compare with your original part before printing. Fitment can vary by trim level and production date.
Specifications
| Part | KIA eNiro MY20/21 Frunk |
|---|---|
| Category | Mechanical/Functional |
| Make | Kia |
| Model | Niro |
| Format | Digital download – STL file for FDM 3D printing |
| Files included | 3 (STL) |
| Part number | CAT-P04557 |
What you get
A digital 3D model (STL file) of this part, ready to print on your own 3D printer or at any local print shop or online printing service. This is a digital download: no physical part is shipped. Not sure it fits your car? Contact us with your vehicle details before you buy.
More Kia parts
Browse all Kia replacement parts or search the full 3D printable car parts library.
Design credit: original design by Don Juape on Thingiverse, licensed CC BY.